Code 30-61-40 - 24VAC30-61-40 - Restrictions on hazardous material transportation across urban and water-proximate facilities. The phone number must be to someone capable of providing information on the material. 172.504 General placarding requirements. (2) Each material must be packaged in the manufacturer's original packaging, or a packaging of equal or greater strength and integrity. (b) DANGEROUS placard. Applicability of placarding requirements 172.500: Placarding is not required for infectious substances, ORM-D, limited quantities, small quantity shipments, and combustible liquids in non-bulk packages. The letters in both words must be at least 38 mm (1.5 inches) high. Emergency responders may have trouble identifying the DOT emergency response telephone number. Hazardous materials may not be shipped in UPS-provided packaging, such as Letters, Boxes, Paks and Tubes. The transfer of electronic data about the hazardous materials shipments does not replace the UPS Shippers Certification of Hazardous Materials. 172123, 56 FR 66261, Dec. 20, 1991]. DIVISION 2.3 POISONOUS OR TOXIC, This class includes materials that are Compressed, Dissolved under Pressure, or Pressurized Cryogenic Liquids, and Liquefied Gases, Includes materials whose Flash Point (FP) is not more than 141F, DIVISION 4.1 FLAMMABLE SOLID DETERMINE WHETHER AMPERE MATERIAL HITS THE DEFINITION OF ONE "HAZARDOUS MATERIAL" PROPER SHIPPING NAME . (3) Placarding is not required on a freight container or aircraft unit load device if it is only transported by air and is identified as containing a hazardous material in the manner provided in part 7, chapter 2, section 2.8, of the ICAO Technical Instructions (IBR, see 171.7 of this subchapter). In a very simplistic sense, placards are big hazard labels, roughly 9.84 inches on each side. 172.512 Freight containers and aircraft unit load devices. Name five hazard classes that require placarding in any amount. For additional information on the registration requirement, you may call 1-800-467-4922 or (202) 366-4109. For transportation purposes, DOT 3 brake fluid is classed as only moderately flammable with a flammability rating of 1. To be transported in the UPS system, these devices must be fully declared requiring shipping papers, proper packaging, marking and labeling. DIVISION 4.2 SPONTANEOUSLY COMBUSTIBLE MATERIAL DIVISION 4.3 DANGEROUS WHEN WET. (6) The EXPLOSIVE 1.4 placard is not required for those Division 1.4 Compatibility Group S (1.4S) materials that are not required to be labeled 1.4S. [Amdt. [Amdt. Washington, DC 20590 Which of the following products are considered hazmat? Refer to the current, Pickup service for hazardous materials is restricted in some areas of Alaska and Hawaii. 5123 (civil penalties) and 5124 (criminal penalties.). In addition to this section, shippers and carriers should check sections 177.834 through 177.854 for any additional handling requirements. 172151, 62 FR 1231, Jan. 8, 1997; 62 FR 39398, July 22, 1997]. DOT Shipping Labels: Hazard Class 4: Dangerous When Wet - Accuform It is the hazmat employer's responsibility to determine the adequacy of the training being presented. (eg: As a hazmat employee, additional specialized training may be required based on the job function and material-specific requirements related to the handling of hazardous materials. (ii) A compartmented tank car which contains both flammable and combustible liquids. ), dash (-), plus sign (+) and conventional parentheses. 17229, 41 FR 15996, Apr. For a vehicle containing one or more lithium batteries that would separately be classified as UN3480 (lithium-ion battery) or UN 3090 (lithium metal battery), the battery or batteries contained in the vehicle are limited to 5kg maximum net weight per package. 172.505 Placarding for subsidiary hazards. 172123, 55 FR 52601, Dec. 21, 1990; 65 FR 50460, Aug. 18, 2000]. Except for bulk packagings and hazardous materials subject to 172.505, when hazardous materials covered by table 2 of this section are transported by highway or rail, placards are not required on, (1) A transport vehicle or freight container which contains less than 454 kg (1001 pounds) aggregate gross weight of hazardous materials covered by table 2 of paragraph (e) of this section; or. This may satisfy the hazardous materials training requirements. developer resources. Dangerous when wet - 4.3 Organic peroxide type B, liquid or solid, temperature controlled - 5.2 Materials poisonous by inhalation - 6.1; these are generally considered liquids or solids that are giving off fumes. However, a bulk packaging must be marked with the appropriate identification number on a CLASS 9 placard, an orange panel, or a white square-on-point display configuration as required by subpart D of this part. The exceptions provided in paragraph (c) of this section do not prohibit the display of placards in the manner prescribed in this subpart, if not otherwise prohibited (see 172.502), on transport vehicles or freight containers which are not required to be placarded. There is a separate section for each of the authorized labels that gives an example of the label and describes the label. The Uniformed Services of the United States generally are not subject to the commerce clause of the Constitution. The representation that a hazardous material is present in a package, container, rail car, aircraft, motor vehicle or vessel. For cigarette lighters or similar devices, UPS does not permit the use of the exception stated in 49 CFR 173.308(e). Regardless of the hazard class, cyanide and cyanide mixtures can not be transported with acids. UPSs conditions incident to transportation may differ from those of other carriers systems due to the distinct UPS methods for sorting, handling, and moving packages. A frequent problem encountered involves the 1,001 lbs. [Amdt. 172130, 58 FR 51531, Oct. 1, 1993; 65 FR 58627, Sept. 29, 2000]. Each person who offers hazardous materials for marine shall describe the dangerous materials on a shipping paper so conforms for the what of the HMR. (4) OXIDIZER placards are not required for Division 5.1 materials on freight containers, unit load devices, transport vehicles or rail cars which also contain Division 1.1 or 1.2 materials and which are placarded with EXPLOSIVES 1.1 or 1.2 placards, as required. (3) A NON-FLAMMABLE GAS placard is not required on a transport vehicle which contains non-flammable gas if the transport vehicle also contains flammable gas or oxygen and it is placarded with FLAMMABLE GAS or OXYGEN placards, as required. HAZARDOUS MATERIALS CARRIER RESPONSIBILITY. "Dangerous when wet" material means a material that, by contact with water, is liable to become spontaneously flammable. Each package is limited to a maximum gross weight of 30kg. Compliance with the current requirements for a CDL with a tank vehicle or hazardous materials endorsement provides a driver with the general knowledge and skills necessary to safely operate a commercial motor vehicle with hazardous materials cargo. Part 177 for highway contains a number of general and specific requirements for loading and unloading hazardous materials in 177.834-177.854. COMMERCIAL DRIVERS LICENSE REGULATION APPLICABILITY : THE RULES IN THIS PART APPLY TO EVERY PERSON WHO OPERATES A COMMERCIAL MOTOR VEHICLE IN INTERSTATE, FOREIGN, OR INTRASTATE COMMERCE AND TO ALL EMPLOYEES OF SUCH PERSONS. (3) Reflective or retroreflective materials may be used on a placard if the prescribed colors, strength and durability are maintained. 172.504 contains a number of notes and exceptions to these requirements. 49CFR part 172.500 regulations dictate that Class 4 Dangerous When Wet placards have a blue background, and bare a Class 4 numeral code in white text. 15, 1976, as amended by Amdt. 172.504 Placarding Table 2. On a COMBUSTIBLE placard with a white bottom as prescribed by 172.332(c)(4), the class number must be red or black. The symbol, text, class number and inner border must be white. Each person who offers for transportation in commerce or transports in commerce one or more of the following hazardous materials must develop and adhere to a transportation security plan for hazardous materials that conforms to the requirements of this subpart. 172.555 POISON INHALATION HAZARD placard. 17229, 41 FR 15996, Apr. For transportation by highway, if a transport vehicle contains hazardous materials for which a shipping paper is required and the transport vehicle is separated from its motive power and parked at a location other than a facility operated by the consignee, consignor, or carrier, the carrier shall (1) Mark the transport vehicle with the telephone number of the motor carrier on the front exterior near the brake hose or electrical connection; or (2) have the shipping paper and emergency response information readily available on the transport vehicle. In order to determine if a particular hazardous material may qualify as a consumer commodity, refer to the section number in Part 173 identified in column 8 of the 172.101 Table for that material. (3) Contains the residue of a hazardous substance in Class 9 in a quantity less than the reportable quantity, and conforms to 173.29(b)(1) of this subchapter. Air service level shipments of UN3171 (Battery-powered vehicle) will only be accepted under the following conditions: Restricted to PAX quantities only, not accepted as CAO. The trefoil symbol on the RADIOACTIVE placard must meet the appropriate specification in appendix B of this part. Hazmat Labels and Marking for Shipments: What You Need - News and Info 172123, 55 FR 52601, Dec. 21, 1990, as amended at 56 FR 66260, Dec. 20, 1991; 57 FR 45460, Oct. 1, 1992; Amdt. These three words are important in that they define when you are subject to the jurisdiction of the Department of Transportation. (This substitutes for the lack of performance tests in UN standards with regard to puncture resistance, abrasion resistance and metal fatigue). Explosive article means an article containing an explosive substance; examples include a detonator, flare, primer or fuse. The shipping name of the material being transported; The UN/ID number of the material; . Special agents of the Department of Transportation can not be denied reasonable access to those areas that fall within the official scope of their duties. The basic description now includes proper shipping name, hazard class, identification number, and packaging group. Placards may be displayed for a hazardous material, even when not required, if the placarding otherwise conforms to the requirements of Subpart F of Part 172 [172.502(c)]. The 12.5 mm measurement is from the outside edge of the placard to the outside of the solid line forming the inner border. Electronic Code of Federal Regulations (e-CFR), Subtitle B - Other Regulations Relating to Transportation, CHAPTER I - PIPELINE AND HAZARDOUS MATERIALS SAFETY ADMINISTRATION, DEPARTMENT OF TRANSPORTATION, SUBCHAPTER C - HAZARDOUS MATERIALS REGULATIONS, PART 172 - HAZARDOUS MATERIALS TABLE, SPECIAL PROVISIONS, HAZARDOUS MATERIALS COMMUNICATIONS, EMERGENCY RESPONSE INFORMATION, TRAINING REQUIREMENTS, AND SECURITY PLANS. Hazardous materials shipments authorized for strong (i.e., non-specification) outer packaging must be in outer packages at the following minimum levels (overpacks are excluded from this requirement): Packages must be in a minimum 200 lbs. 4. Consumer commodities are materials that are packaged and distributed in a form intended for, or suitable for sale through retail sales. DIVISION 1.2 PROJECTION HAZARD How to Comply with Federal Hazardous Materials Regulations | FMCSA Shipping paper requirements are contained in 49 CFR Part 172 Subpart C. For the purpose of the hazardous materials regulations, a shipping paper is any shipping document whose purpose is to communicate a hazard, and conforms to the requirements contained in this Subpart. Performance tests for UN packaging, including design qualification tests and periodic retests, are included in Part 178. on each side. 172148, 61 FR 50255, Sept. 25, 1996, as amended by 66 FR 45379, Aug. 28, 2001; 69 FR 64473, Nov. 4, 2004; 75 FR 5392, Feb. 2, 2010; 76 FR 43528, July 20, 2011; 77 FR 60942, Oct. 5, 2012; 81 FR 35540, June 2, 2016; 85 FR 27878, May 11, 2020]. The symbol, text, class number and inner border must be white. Choosing an item from For procedures and limitations pertaining to the display of identification numbers on placards, see 172.334. Technical names are not required for bulk packages. 5101 et seq. The international standards have general requirements for materials, construction and a maximum capacity as compared to detailed DOT specifications for non-bulk packagings formerly contained in 49 CFR, Part 178. If the carrier's equipment has an emergency response guide or similar document on board there is no requirement to provide a separate emergency response document. Around which hazard classes must you never smoke? A person domiciled outside the United States who offers HM solely from outside the United States. It is the responsibility of the packaging manufacturer and the person who offers hazardous materials for transportation, to the extent that assembly functions including final closure are performed by the latter, to assure that each package is capable of passing the prescribed tests. Except as otherwise provided in this subchapter, each bulk packaging, freight container, unit load device, transport vehicle or rail car containing any quantity of a hazardous material must be placarded on each side and each end with the type of placards specified in tables 1 and 2 of this section and in accordance with other placarding requirements of this subpart, including the specifications for the placards named in the tables and described in detail in 172.519 through 172.560. the hierarchy of the document. The symbol, text, class number and inner border must be white. A person who uses one or more of its employees in connection with: transporting hazardous materials in commerce; causing hazardous materials to be transported or shipped in commerce; or representing, marking, certifying, selling, offering, manufacturing, reconditioning, testing, repairing or modifying containers, drums, or packaging as qualified in the transportation of hazardous materials. Any agency or instrumentality of the Federal government, for the purposes of 49 U.S.C. The word shipper is frequently used by industry in place of the word "offeror." Domestic and international shipments must be identified, and our placards are available in heavy duty polycoatedtagboard, which is water resistant. The words FUEL OIL must be white. The symbol, text, class number and inner border must be white. (a) Except as provided in paragraphs (c) and (d) of this section, each person who offers for transportation a bulk packaging which contains a hazardous material, shall affix the placards specified for the material in 172.504 and 172.505. Mullen test. The hazardous materials regulations have changed significantly over the last several years. Select the appropriate packaging based on the amount of hazmat you are looking to ship. Hazardous materials may be offered in authorized single packaging, subject to the following conditions: May be offered for ground service level only in the 48 contiguous United States. The official, published CFR, is updated annually and available below under 17264, 46 FR 5316, Jan. 19, 1981; Amdt.
